UsageSikaEmaco® S 422 is used for structural repair work and suitable for:
|
AdvantagesSikaEmaco® S 422 provides the following beneficial properties:
|
Product Details
Composition
Polymer containing cementitious mortar with different additives and synthetic fibres
Shelf life
12 months from date of production
Storage conditions
Store in a cool, dry area in original sealed packaging and at temperatures between +5 °C and +35 °C. Protect from direct sunlight, heat and moisture.
Compressive strength
28 day |
|
w/p = 0.13 |
≥ 65 N/mm2 |
Tensile adhesion strength
≥ 1.5 N/mm2 (or concrete failure) |
(EN 1542) |
Application
Mixing ratio
3.2 – 3.5 L of water per 25 kg bag
Layer thickness
Min. 10 mm
Max. 40 mm
Ambient air temperature
+5 °C min. / +40 °C max.
Substrate temperature
+5 °C min. / +40 °C max.
Fresh mortar density
~2.21 kg/l (+25 °C)
Yield
~12.9 L / 25 kg bag
MIXING
Mix the full bag of SikaEmaco® S 422 with the necessary amount of cold water in a clean bucket. Add the SikaEmaco® S 422 powder slowly to the water while mixing continuously for at least 3 to 5 minutes and until a homogeneous consistency is achieved.
SikaEmaco® S 422 is best mixed in a forced action mixer. Slow speed double paddle drill can be also used for mixing. Do not mix at faster rate than 500 rpm. The obtained mix results should be very creamy, easily spreadable and thixotropic.
APPLICATION
Apply SikaEmaco® S 422 while the bonding agent is still wet. The mortar can be applied by spatula or trowel.
For any thickness more than 40 mm, SikaEmaco® S 422 must be applied in several layers. As soon as the mortar has started to set it can be smoothed by wooden or synthetic float. For fine surface finish SikaEmaco® N 907 or SikaRep® Fine N can be applied over the SikaEmaco® S 422.
CURING TREATMENT
Where ambient conditions may lead to rapid surface drying, the use of light water fogging, damp hessian and polythene sheet or application of a suitable water based curing compound like Sika® Antisol range is recommended. Do not commence fogging until final set has been reached.
CLEANING OF EQUIPMENT
Clean all tools and equipment with water immediately after use. Hardened SikaEmaco® S 422 can only be removed mechanically.
Reviews
There are no reviews yet.